Lifestyle
DevelopingFive roof-building mistakes to avoid to prevent leakage and cracks
Many people give more attention to walls, floors and doors than to the roof, yet small errors made during roof work often go unnoticed at first. Their effects appear years later, when water drips from the ceiling, walls turn damp and cracks form. A strong roof depends on good materials, the right concrete ratio, careful casting and care after the concrete is laid.
Good-quality steel, cement, sand and aggregate should be used, and cheap material avoided. For M20 grade concrete, one part cement, one and a half parts sand and three parts aggregate can be used, though mix design, water quantity and site conditions also matter, so casting should be supervised by an expert engineer. Waterproofing chemicals can be mixed into concrete, and after curing, the surface should be cleaned and coated.
Care does not end at construction. Small cracks or holes may seem minor, but rainwater can seep in and cause rust in the steel, and weaken the concrete. Cracks should be repaired in time, and the roof should be cleaned daily during the monsoon, with drainage channels kept open so water does not collect.
Key points
- Use good-quality steel, cement, sand and aggregate rather than cheap material.
- For M20 grade concrete, a mix of one part cement, one and a half parts sand and three parts aggregate can be used.
- Waterproofing chemicals can be added to concrete, and a waterproof coating should be applied after curing.
- Small cracks should be repaired in time, as rainwater can cause rust in the steel inside the roof.
- Clean the roof daily during the monsoon and keep drainage channels open so water does not collect.
Coverage from
This story was put together automatically from the sources above. Open a source to read its original report. How nuze makes stories